Home > All About Helicopters > Getting Started on RC Helicopters – Part 5 (Gyros Explained)

Getting Started on RC Helicopters – Part 5 (Gyros Explained)

So you’re new to radio controlled helicopters and you start to hear about gyros. Wondering what they are, what are they used for or even how they should be used? This post will clarify everything about gyros and i hope in the end you will have a better and clear idea about them.

The purpose of the gyro is to stabilize the tail. Without it, the model would be almost unflyable. Early gyros had a motor and two flywheels inside and at the time worked quite well but they are no match compared to more recent piezo gyros, which have no motor, but use an electronic sensor instead.

Piezo Gyros

Modern piezo gyros have never been so good and are no longer an expensive alternative but an essential part of the radio system. Modern peizo gyros can cost anything from $50 to $400. So how much should you spend and which one should you buy?

Well at the lower end of the scale, the gyro will be single rate, adjusted on the gyro itself and will not have pilot authority. At the top of the range, it will probably be dual rate in both normal and heading lock mode (sometimes called heading hold or AVCS), selectable from the transmitter, and it will also have full pilot authority.

Modern piezo gyros have a very fast response and will need a servo that can keep up with the gyro output. Servo speed is measured by the number of seconds it takes for the servo to turn 60 degrees, so a digital servo with a speed of 0.12s/60 to 0.08s/60 is the ideal but you will have to pay around $70 to $150 for it.

Gyro Gain

The best way to adjust gyro gain is to turn it up until the tail wags in forward flight and then turn it down a little. You should be able to get near 100% gain. If you can’t, then try changing the length of the rudder servo arm. There is no point in spending serious money on a good gyro and then only using 50% gain.

Pilot Authority

On a standard gyro, when you input a rudder command the gyro will try to correct the tail back to the centre. The higher the gain on the gyro, the less tail authority you will have. With pilot authority, the gyro gain decreases as you input commands so you can have 100% gyro gain and still have full tail authority.

Heading Lock

With the gyro in normal mode, the tail will weathercock to some extent so when flying circuits or hovering in to wind the tail will tend to follow the line of the model. In heading lock mode, the tail stays wherever you put it, so it is quite easy to fly the model sideways or backwards at speed without losing the tail position. The only downside to heading lock mode is that you have to steer the tail all the time as it will not naturally follow the model. And if you enter a maneuver, say a loop, with the tail offline it will stay offline throughout the maneuver. If you are not sure which mode the gyro is in, with the radio on and without the engine going, move the rudder control fully to one side: if heading lock is selected, the servo will stay at one end until you move the stick back to the other side.

Mixing Makes

I have used Futaba, JR, and CSM gyros on JR radio systems with no problems at all. Anyhow, i advise you to use a matching rudder servo in the case of JR or Futaba, as they were designed to work with their own servo.

Advertisements
  1. No comments yet.
  1. No trackbacks yet.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: